Paver transverse slope instrument installation: the controller is installed, will play in "STANDBY" state, control valve switch connected cable, after must set controller "zero". This is a list of the mobile phone "zero" setting method. 1. Use level, make the actuator (e.g., screed) is in a state level; 2. Open the machine power supply device, give a controller of power supply; 3. The sensitivity knob to play in the middle state; 4. Push bring or ▼ button, make the controller on the two output light is put out; 5. Hold the R key to bring on the LCD, ▼ marks appear at the same time, and no longer flashing, later, still hold the R key, push bring or adjusted ▼ button, on the LCD display value of 0.00. * note: if the zero point set, there is still a control valve flash light, bright, must repeat the above step 4, 5, 2; 4 seconds later, a new calibration values will be stored in the controller.

 

Disclaimer 丨 part content source network! This article only for the exchange of learning, copyright belong to author, some pictures and content delivery failed to get in touch with the original author, if the source tagging error or violate to your rights and interests please to inform, we will delete immediately.

 

 

Companies to introduce

Supply the paver accessories, roller accessories, milling planer machine accessories, paver scraper drive shaft, scraper drive shaft assembly, leveling instrument, leveling instrument stents and hydraulic pump and accessories. Wearing parts, our factory also supply paver paver balance beam, stirring shaft, pedal, transporting base plate, blade, iron tablets, reducer, caterpillar, crawler plate, roller, scraper chain, transporting chain, etc.

 

 

 

Contact: manager liang

 

Contact: 13645201509

 

(the same WeChat number)

 

QQ: 2870202745